L-36.com

Dimensions of Beneteau 30 e

Updated 10/25/2012



Selected Measurements for Beneteau 30 e

BOAT
I
J
P
E
ISP
JSP
PY
EY
Disp
LWL
DRAFT
Beneteau 30 e 37.7 11.3 32.5 11 0 0 0 0 7100 26.83 5.5

Links to our Multi Vendor Used Sail Directory for Beneteau 30 e

Other Data Base Entries for beneteau 30*

Click on boat nane to use
BOAT   I J P E ISP SPL PY PELWLDRAFTDISP
BENETEAU 30   36.8 11.2 32 11
Beneteau 30 36.8 11.2 32 11 25.425.57500
BENETEAU 30 38.3 11.5 32.5 9.5 38.3 11.5
BENETEAU 30 FST (OLD) 37.6 11.5 32.3 9.5
BENETEAU 30 E 37.7 11.3 32.5 11
Beneteau 30 E 37.7 11.3 32.5 11 26.835.57100
Beneteau 30 E Fr 36.1 10.9 36.1 11.8 26.975.56834
BENETEAU 30 E Frac rig 36.1 10.9 36.1 11.8
BENETEAU 30 E Short rig 33.6 11.2 28.4 11
Beneteau 30 E Sm 33.6 11.2 28.4 11 26.835.57100
BENETEAU 30 E Tall rig 39.2 11.3 33.8 11.3
Beneteau 30 E Tm 39.2 11.3 33.8 11.3 26.835.57100
BENETEAU 30 FST ES Frac 36.1 10.9 36.1 11.8
BENETEAU 30 FST E 37.7 11.3 32 10.7
BENETEAU 30 RC 37.6 11.5 32.4 9.5
BENETEAU 300 OCEANIS 37 10.8 37.9 13
BENETEAU 300 SPIRIT 40.3 12 37.2 12.6 40.3 12
BENETEAU 305 39 11.3 33.8 11.2 39 11.3
Beneteau 305 39.3 11.4 33.6 11.1 26.755.588242
BENETEAU 305 FST 39 11.4 33.8 11.2
BENETEAU 305 FST T 38.5 11.3 33.2 10.7
BENETEAU 305 SD 39 11.3 33.8 11.2 39 11.3
Beneteau 305 Sd 39.3 11.4 33.6 11.1 26.754.338242
BENETEAU 305 Short rig 37.7 11.3 32 10.7
Beneteau 305 Sm 37.65 11.28 32.01 10.69 26.755.588242
BENETEAU 305 SM 37.7 11.3 32.4 10.7 37.7 11.3
BENETEAU 30E 36.8 11.3 32.5 11 36.8 11.3
BENETEAU 30E FR 36.1 10.9 36.1 11.8 36.1 10.9
BENETEAU 30E SD 36.8 11.3 32.5 11 36.8 11.3
BENETEAU 30E SM 33.6 11.3 28.4 11 33.6 11.3
BENETEAU 30E TM 39.2 11.3 33.8 11.3 39.2 11.3
Click Here for other boat types or to check dimensions from other data bases. We now offer three data bases.

Sail Area Calculations

BOAT
I
J
P
E
ISP
JSP
PY
EY
Disp
LWL
DRAFT
Beneteau 30 e 37.7 11.3 32.5 11 37.7 11.3 0 0 7100 26.83 5.5

sailboat rig dimensions The following formulas are approximate
Sail areas depend on lots of factors, leach hollow, foot round, luff hollow etc. Also, remember that jib sail area in general is based on the forestay length, I. But all things considered, these numbers are close but should not be considered exact. They are rules of thumb, not measurements of a this specific boat.

Mainsail

Mainsail = (P x E) / 2 = 179 sq ft
Racing Mainsail (add 10%) = 197 sq ft

Genoa

155% Genoa = (( J x I ) / 2) x 1.65 = 351 sq ft
135% Genoa = (( J x I ) / 2) x 1.44 = 307 sq ft

Jib

  _______
LP of full fore triangle = ( I x J ) / √  I2 + J2 = 10.8
Jib size to fill fore triangle = 96%
100% Jib = ( I x J ) / 2 = 213 sq ft

A more accurate LP calculator is HERE

Spinnaker

Spinnaker Area = Max Luff x Max Girth x ( 70-85%) = 532 to 646 sq ft
"Square" Spinnaker Area = Max Luff x Max Girth) = 761 sq ft
AC Area = 634 sq ft
Maximum Luff (.95 * sqrt (JSP^2 + ISP^2) = 37.39 feet
Maximum Girth = 1.8 * JSP = 20.34 feet
Ref

DEFINITIONS

"P" is the luff length of the mainsail, measured along the aft face of the mast from the top of the boom to the highest point that the mainsail can be hoisted or black band.

"E" is the foot length of the mainsail, measured along the boom from the aft face of the mast to the outermost point on the boom to which the main can be pulled or to the black band.

"I" is measured along the front of mast from the genoa halyard to the main deck. The main deck is where the deck would be if there were no deckhouse.

"J" is the base of the foretriangle measured along the deck from the headstay pin to the front of the mast.

"JSP" is the length of the spinnaker pole or the distance from the forward end of the bowsprit (fully extended) to the front face of the mast.

"ISP" is measured from the highest spinnaker halyard to the deck.

"PY" and "EY" are, respectively the luff length and foot length of the mizzen of a yawl or ketch measured in the same way as for the mainsail.

"IY" is the measurement from the staysail halyard to the deck.

"JY" is the measurement from the staysail stay to the front face of the mast.

"LP" is the shortest distance between the clew and the luff of the genoa.


Data*

This data is supplied as a reference and all boat dimensions should be verified before using it in any critical application.
The information in these data bases is a starting point. There are errors as you can see as the different data bases do not always agree. In addition, some boats have been modified from stock and will not match the data in these databases. None of this data has been checked by L-36.com so please always check your boat before relying on this data.
Data is from a variety of sources.
db = SBD is used under the Creative Commons License sailboatdata.com (sailboatdata.com) / CC BY 3.0
db = PHRF is the PHRF Critical Dimensions database
db = WEB is the commonly available data found on many web sites
db = BIG is a combination of all of the above.


NOTICE: Some pages have affiliate links to Amazon. As an Amazon Associate, I earn from qualifying purchases. Please read website Cookie, Privacy, and Disclamers by clicking HERE. To contact me click HERE. For my YouTube page click HERE